Permatex 27200 Hiigh Temperature Threadlocker Red, 10 ml

Works as intended

Very pleased with the Permatex High Temp Red 24026. I employ this to secure the set screws on AR15 low profile gas blocks, which are exposed to very high temperatures and, if they fail, would cause the entire gun to cease functioning. Most of my work is on law enforcement patrol carbines and rifles, so ensuring proper function for the people that protect all of us is VITAL. This is rated to maintain 90% of its holding strength up until 450 degrees F. However, and this is good news, it states that you must heat it to past 600 degrees F to begin to remove it...and even then it requires substantial amounts of force (think "breaker bar" or a miniature equivalent) to break the fastener loose. This protects against vibration loosening and ALSO protects the threads from corrosion via oxidation. I recommend this for any item that is being installed in a "permanent installation".....i.e something that simply cannot come loose unless a MAJOR repair or planned parts replacement is begun. AR15 gas blocks, engine bolts, etc. You can remove it via the judicious use of a blow torch and a lot of elbow grease, so this may make it unsuitable for some smaller fasteners or weaker setups (or aluminum if you want it to NOT be permanent). For fasteners that you may want to remove, use a blue variant (either Loctite, Vibra-tite [my favorite], or permatex blue).

This is a very good quality thread lock compound. It lubricates the threads for assembly but doesn’t take long for it to set and lock the threads. Just understand that the application cannot be undone without a high heat torch. The price was better than I saw at the auto parts store. I used this thread lock on the studs that thread into the crankshaft where the flywheel and outdrive coupler attach with flare nuts. Whoever put together the boat engine originally didn’t use thread lock as the studs slowly loosened and some actually fell out. Not wanting to pull the engine out again, I throughly tested the installed studs with a torch and a pair of vice grips to make sure the engine heat would not compromised the thread lock. I heated up the studs to about 300 degrees. I could not budge the studs at all. Perfect!

Came in handy with sportster primary, stator, rotor, friction plate work! I had to remove one bolt after I used this stuff…it works!

Used to seal a rethread on a spark plug

Great product and fast shipping. Was exactly as described. Packaging was great.

Let cure first before Putting screws in on Helio Coils

I bought a cast iron knight fireplace set on Amazon. I read a review and the person said that the nuts and the bolts to hold the utensils together would come loose so he recommended using Permatex Threadlocker Red. I bought this on Amazon and it did the trick. The heat of the fireplace does not affect the glue at all.

他社で量が少ない耐熱高強度のネジロックが廃番になってしまいこれに切替え デフを組む際のリングギヤボルトに使用し、問題なく走ってます

液が出なかったので、返品交換になったが、交換品もボルト2本分の量しか出ない。

Pour des assemblages permanent, ce produit est parfait.

worked as advertised everything fine so far.

i will order more if it was cheaper